250 54 which requires the resistance to ground of a single made electrode e g ground rod to be 25 ohms or less.
Ground rod resistance requirement.
If this additional electrode is another ground rod it must be driven at least 6 away.
There is no requirement to retest the resistance.
On jobs where a building or structure.
For instance if a ground rod is driven into a very rocky and dry area it may not conduct electricity into the ground well.
P2 and c2 connect to a separate all metallic grounding point like a water pipe or building steel.
Resistance of a single ground rod exceeds 25 ohms to ground and the metal underground water line is the only other available electrode an additional electrode must be installed.
Ground rod current source lightning average current 30 000 amps.
This does not create the best ground but it meets the bare minimum of the code.
In some instances ground rods can be installed in areas where the earth has a lot of resistance.
Unfortunately there is not one standard ground resistance threshold recognized by all certifying agencies.
In areas where driving ground rods may be impractical the two point method can be used.
This requirement clarifies that the supplemental electrode system must be.
In areas where codes require two ground rods because of high electrical resistance in the soil the rods must be spaced at least 6 feet apart and interconnected by a buried jumper wire.
Find out why the national electrical code 25 ohms or less rule may have less to do with power quality than you think.
I do not know of an equivalent requirement in the british standards.
If this is the case for your ground rod the best solution is to drive a different rod into a different location.
In practice for a residential structure most electricians place two ground rods and call it done.
With this method the resistance of two electrodes in a series is measured by connecting the p1 and c1 terminals to the ground electrode under test.
The length of a ground rod plays a much bigger role in its final ground resistance measurement and it goes without saying that it takes longer to drive a longer ground rod.
Grounding and bonding transient voltages and currents at data port or cable connections voltage difference.
Ideally a ground should be zero ohms of resistance but.
